Xbox 360 JTAG Tutorial - Part 1 On YouTube.
Watch in HD. In this video series, which will show how the JTAG is performed on a modified Xbox 360. This tutorial assumes a working knowledge of mid-level electronics. Disclaimer: If after doing this tutorial, Xbox 360 is damaged and / or inpoerable, I accept no responsibility for your loss. Follow the instructions at your own risk. Please complete the project requirements: - A PC or laptop with LPTDoor. - A CAT5 cable. - A cable or LPT connector. - A soldering iron. - Ability to weld relatively good. - An Xbox 360 motherboard with a Xenon version and a dash under the 8xxx. - Torx 8 and 10, and perhaps a screwdriver. To identify the motherboard as well as feedback to determine the profitability of your console, you can refer to the following figure: www.360-hq.com If the card-side power available is the first image, and you do not have HDMIPort, it has a Xenon motherboard. Please do not ask me about downgrading the dashboard, if there is a possibility, the change JTAG, an updated console, or get help with everything related to online fraud (10 prestige). The first two are impossible, will never happen again. To find the revision number of the dashboard, select "System Settings" under "My Xbox" on the dashboard. In the new window select "Console Settings" and then "System Information" .. The dashboard overhaul...
Keywords: microsoft, xbox, 360, mod, hack, JTAG, how, to, install, tutorial, part, soldering, wire, nandpro
No comments:
Post a Comment